112
Figure 4-113
4.13.2
Data and Time
From Main menu->SETTING->SYSTEM->GENERAL, you can go to the general interface. See Figure
4-114.
System time: Here is for you to set system time
Date Format: There are three types: YYYY-MM-DD: MM-DD-YYYY or DD-MM-YYYY.
Date Separator: There are three denotations to separate date: dot, beeline and solidus.
DST: Here you can set DST time and date by week or by date. Please enable DST function and then
select setup mode. Please input start time and end time and click Save button.
Time Format: There are two types: 24-hour mode or 12-hour mode.
NTP: It is to set NTP server, port and interval.
Note:
Since system time is very important, do not modify time casually unless there is a must!
Before your time modification, please stop record operation first!
After completing all the setups please click save button, system goes back to the previous menu.
Summary of Contents for k-nl304k
