21
K-NL316K
4. Turn the device upside down
and then turn the screws in
firmly.
5.
Fix the HDD firmly.
6. Connect the HDD cable and
power cable.
Note: Be careful so that the
cables are not in contact with
the edge of the HDD
.
7. Put the cover in accordance
with the clip and then place the
upper cover back.
8. Secure the screws in the rear
panel and the side panel.
1. Use the screwdriver to
loose the screws of the rear
panel and then remove the
front cover.
2.
Put the HDD to the HDD bracket
in the chassis and then line up the
four screws to the four holes in the
HDD. Use the screwdriver to fix the
screws firmly to secure HDD on the
HDD bracket
3. Connect to the HDD data cable to
the main board and the HDD port
respectively. Loosen the power cable
of the chassis and connect another
end of the power cable to the HDD
port.
Summary of Contents for k-nl308k
