48
Call Tour
In Figure 4-31, input tour value and then click
to call a tour. Click again
to stop call.
Call Scan
In Figure 4-31, input autoscan value and then click
to call a tour. Click again
to stop
call.
Autopan
In Figure 4-31, click
to enable the camera to rotate.
System supports preset, tour, pattern, scan, rotate, light and etc function.
Note:
Preset, tour and pattern all need the value to be the control parameters. You can define it as you
require.
You need to refer to your camera user
’
s manual for Aux definition. In some cases, it can be used for
special process.
Aux
Click
, system goes to the following interface. The options here are defined by the protocol. The aux
number is corresponding to the aux on-off button of the decoder. See Figure 4-37.
Figure 4-37
4.7
Record and Snapshot
The record/snapshot priority is: ALARM->MOTION DETECT->SCHEDULE.
4.7.1
ENCODE
4.7.1.1 Encode
Encode setting is to set IPC encode mode, resolution, bit stream type and etc
From Main menu->SETTING->REMOTE->ENCODE, you can see the following interface. See Figure
4-38.
Channel: Select the channel you want.
Summary of Contents for k-nl308k
