Notice
Check the following if you cannot connect the unit to the network.
•
If the orange LED on the LAN connector ( ) does not light.
–
The unit is turned on.
–
The unit is not in sleep mode.
–
The unit is correctly connected to a router or hub with the LAN cable.
–
The LAN cable or LAN connector is not damaged.
•
If the LED (green) of the LAN connector ( ) is blinking.
–
Check the settings with the Network Setting Tool.
2
1
15.2.2 Configuring wireless LAN settings
Note
•
As for Simple AP mode, refer to "4.3.3.1 Simple AP mode" (page 26).
1.
Start Network Setting Tool.
2.
Select [Wireless LAN (Station mode)] as the connection method for the scanner.
•
Display the current settings.
3.
Click [Change].
4.
Select the configuration method from the following, and then configure the network settings follow the
instructions on screen.
–
[Search and Select an Access Point]
–
[Enter Wireless LAN Settings Manually]
5.
Click [OK].
Item
Description
IP Address
Set the IP address.
Network Name (SSID)
Set the network name (SSID).
Connection Type
Set the connection type.
Network Authentication
Type
Set the network authentication type.
Data Encryption Type
Set the data encryption type.
Network Key
Set the network key.
15.2.2 Configuring wireless LAN settings
137
