6 Operation Panel
6.1 About LED
The status of the scanner is displayed by the LED (Green) as shown in the table below:
LED (Green)
Status
OFF
Error
ON
Ready mode or Scanning
Notification mode
Blinking (Slow)
or Cleaning mode
Blinking (Fast)
Warming up
Blinking (Fast, 2 times consecutively)
Double Feed Skip mode
Blinking (Fast, 3 times consecutively)
Dog-ear Detection Skip mode
*1
If the power off feature in sleep mode is enabled, and if no operation is performed for a certain period of time, the scanner will turn
off automatically. Press the power button ( ) of the scanner to turn it on. You can enable/disable the power off feature, and
change the time until the scanner turns off. See "Function Setting" (page 38).
*2
For details about the error, refer to "15.11 Error Codes and Error Messages" (page 151).
*3
For details about the notification, check the LCD or User Utility.
*4
If no operation is performed for 15 minutes or longer, the scanner will enter sleep mode automatically to conserve energy. Press
the Start/Stop button (
) on the scanner’s operation panel to return to ready mode. The time until the scanner enters sleep
mode can be changed. See "Function Setting" (page 38).
6 Operation Panel
33
