4.2.3.2 Station mode
After installing the software, you can use this unit in station mode of wireless LAN by the following
procedure.
1.
Turn ON the wireless LAN ON/OFF switch.
2.
Turn ON the unit's power (page 28).
•
If the unit is in simple AP mode, switch the unit to station mode (page 23).
3.
Press the WPS button on your wireless access point.
4.
Connect the scanner to wireless access point.
i.
Press and hold the Skip button (
) for 2 seconds or more.
ii.
Press the single touch scan button 1.
•
Perform this step within 1 minute of performing step 3.
•
The LED
(Green) blinks while connecting. When the connection is complete, the LED
(Green) stops blinking and turns on.
Note
•
After switching the LAN mode, connection with paired computers may be interrupted. To re-establish
connectivity with existing PC's over the LAN, the Network Scanner Select Tool should be used. For
details, refer to "6.1.6 Changing the Scanner Connected over LAN" (page 32).
4.2.3 When using this unit with a wireless LAN connection
24