10.2 Perform Network Settings with USB
Connection
You can connect the scanner to your computer with the USB cable, and then perform the following settings
with Network Setting Tool.
For details about network-related settings, consult your network administrator.
Settings
Item
Description
Host Name
Set the host name for the scanner.
DHCP
Enable (On) or disable (Off) DHCP.
AutoIP
Enable (On) or disable (Off) AutoIP. If DHCP is disabled, this setting cannot be
changed.
IP Address
Set the IP address. If DHCP is enabled, the IP address will be set
automatically and cannot be changed.
Subnet Mask
Set the subnet mask. If DHCP is enabled, this will be set automatically and
cannot be changed.
Default Gateway
Set the default gateway. If DHCP is enabled, this will be set automatically and
cannot be changed.
DNS Server 1
Set the primary DNS server. If DHCP is enabled, this will be set automatically
and cannot be changed.
DNS Server 2
Set the secondary DNS server. If DHCP is enabled, this will be set
automatically and cannot be changed.
WINS Server 1
Set the primary WINS server. If DHCP is enabled, this will be set automatically
and cannot be changed.
WINS Server 2
Set the secondary WINS server. If DHCP is enabled, this will be set
automatically and cannot be changed.
Notice
Check the following if you cannot connect the unit to the network.
•
If the LED (Orange) ( ) of the LAN connector is not illuminated, confirm that the LAN cable is
connected to the LAN connector of the unit correctly.
•
If the LED (Green) ( ) of the LAN connector is blinking, check the network settings using the Network
Setting Tool.
2
1
10.2 Perform Network Settings with USB Connection
79