Shading Adjustment
50
5
The shading paper will be fed into the
scanner in a little while after the
shading start. You will hear a clicking
sound while shading is being
performed.
Be sure not to open the
front door or turn off the power.
6
After the shading paper is ejected, the
“Turn Plates!” message will appear,
open the front door and change the
upper and the lower reference plates to
the black side. (See pages
through
.)
Be sure not to turn off the power.
7
Close the front door.
The scanner will continue automatically.
≥
The shading restarts and the LCD
displays as shown on the right.
8
The shading is complete when the
LCD displays as shown on the right.
9
Press the HOME key.
≥
The LCD display returns to “Ready”.
Note: If you need to use white reference, please remember to rotate the reference plates back to white.
¥
Caution
If the scanned images are still lined after the shading adjustment has been performed and if these lines are not elim-
inated even after the scanning section glass areas have been cleaned, it means that the shading has not been com-
pensated properly. Clean the parts again, and then proceed with the shading adjustment.
D o n ’ t
t u r n o f f
> > > > > > > > > > >
> > > > > > > > >
T u r n
P l a t e s !
F r o n t : W – > B
>
B a c k : W – > B
D o n ’ t
t u r n o f f
> > > > > > > > > > >
> > > > > > > > >
N O E r r o r
R e a d y
Summary of Contents for KV-S3105C
Page 6: ...Notice 6 Caution Labels...
