Cleaning the Unit
39
∫
Cleaning the starting, skew and ending sensors
How to clean sensors (detectors) and reflectors.
Remove the brush from the accessory blower and blow off the dirt with the blower.
1
Turn off the scanner.
2
Pull the exit door release to open the
exit door.
3
Blow off the dirt on the surface of the
starting, skew (L), skew (R), and
ending sensors with the accessory
blower.
4
And blow off the dirt from the reflector
sheets for the starting, skew (L), skew
(R), and ending sensors with the
blower.
5
Close the exit door.
≥
When you close the exit door, close it
securely until it is locked.
Blower
Sensor (detector)
Ending sensor
Skew (L) sensor
Skew (R) sensor
Starting sensor
Reflector sheet for
skew (R) sensor
Reflector sheet for
starting sensor
Reflector sheet
for skew (L)
sensor
Reflector sheet for
ending sensor
