Display Panel Instructions
27
¥
Other display explanations
Display
Content
This will be displayed when scanning is started until it is
completed.
After completion, “Ready” will be displayed.
If the STOP key is pressed, scanning will stop. This will be
displayed when the STOP key was pressed during scanning.
Even if the STOP key is pressed in a setting mode, this will be
displayed. Then the scanner will return to setting mode after
stopping scanner operation.
This will be displayed when the STOP key is pressed and the
scanner stops.
Even if the document remains in the scanner, “JAM” will not
be displayed.
If the document remains in the scanner, open the front door
and remove it.
Then “Ready” will be displayed.
This will be displayed after setting scanning to start with a
host computer.
If the document is set and the START key is pressed,
scanning will start.
This will be displayed while a system program is downloaded.
Do not turn the scanner’s power off while this message is
displayed.
If sleep mode is enabled, the scanner enters the sleep mode
when the scanner is idle for the specified time. The back light
goes off, “Sleep” appears on the LCD and the LED on the
display panel starts flashing slowly in orange.
For setting the sleep mode, see page 26.
By pressing any key on the scanner or issuing the scan
instruction from the PC, the scanner returns from the sleep
mode.
S c a n n i n g . . .
1 2 3 4
S t o p p i n g . . . W a i t !
S c a n n e r
S t o p p e d
1 2 3 4 5 6
P r e s s
S T A R T
K e y
1 2 3 4
P r o g r a m
D o w n l o a d
D o n ' t
t u r n
o f f
S l e e p
Summary of Contents for KV-SS905C
Page 6: ...Notice 6 Caution Labels...
