Setup
Before setting up the equipment following the procedures below, refer to pages i)–
vi).
KX-TGP600
We recommend configuring these settings with your administrator. You can
configure the settings through the Web user interface by entering the IP address
of the KX-TGP600 in the Web browser. For details, consult your administrator.
KX-TPA60/KX-TPA65
Registering to a base unit
Up to 8 handsets can be registered.
1.
Base unit of KX-TGP600:
Press and hold the handset locator button on the right side of the base unit
for about 4 seconds until the indicator flashes red.
R
The next step must be completed within 2 minutes.
2.
KX-TPA60/KX-TPA65:
Press and hold
about 3 seconds, then wait until a long beep sounds.
KX-A406
Registering to a cell station (Easy Registration)
1. Turn on the repeater by connecting the AC adaptor.
R
If the repeater is unregistered, the indicator will flash red, and the repeater
automatically enters Easy Registration mode.
R
When the repeater has found a cell station, the indicator will turn green.
Registration is completed.
Note
R
In Manual Registration, the repeater can be registered to another repeater to
create a cascade configuration. For details, refer to the Installation Manual of
the repeater.
2
Setup
Summary of Contents for KX-A406
