1. Introduction and Installation
10
4
Insert the blue gear of the ink film roll into the front
left slot of the unit (
3
) and the white gear of the ink
film roll into the rear left slot of the unit (
4
).
L
The ink film is safe to touch and will not rub off on
your hands like carbon paper.
L
Make sure the blue gear (
3
) and white gear (
4
)
are installed as shown.
5
Turn the blue gear (
5
) in the direction of the arrow
until the ink film is tight (
6
) and at least one layer of
ink film is wrapped around the blue core (
7
).
6
Close the back cover securely by pushing down on
the dotted area at both ends (
8
).
7
Close the front cover securely.
3
4
5
6
Correct
Incorrect
7
Tight
1 turn
No ink film is wrapped around the blue core.
Slack/Crease
Reverse
8
FP701FX-PFQX2792ZA-en.book Page 10 Friday, July 13, 2007 3:34 PM