Registering the
smart plug
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the smart plug, it
must be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the
[Home
Network]
app.
Using registration buttons
1
Hub:
Press and hold
M
OTHER
DEVICE
N
until the LED indicator
blinks slowly in green.
2
Smart plug:
Press and hold
M
N
until the
LED indicator blinks slowly in
green (page 8).
R
When registration is complete,
the hub sounds one long beep.
Note:
R
To cancel without registering the
smart plug, press
M
N
on the hub
and on the smart plug again.
R
If registration fails, the hub sounds
several short beeps.
Using the app
When you register the smart plug by
using the
[Home Network]
app, you
can assign a name to your devices and
group them by location. For more
information, refer to the User’s Guide
(page 11).
Wireless
communication
range
The wireless communication range of
each device in the system from the hub
is approximately 50 m indoors and
approximately 300 m outdoors.
Wireless communication may be
unreliable when the following obstacles
are located between the hub and other
devices.
R
Metal doors or screens
R
Walls containing aluminium-sheet
insulation
R
Walls made of concrete or
corrugated iron
R
Double-pane glass windows
R
Multiple walls
R
When using each device on
separate floors or in different
buildings
Note:
R
The LED indicator blinks in red if it is
out of range of the hub. In this case,
confirm all connections, including
those of the hub.
10
Setup
