Registering the
remote
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the remote, it must
be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the
[Home
Network]
app.
Using registration buttons
1
Hub:
Press and hold
M
OTHER
DEVICE
N
until the LED indicator
blinks slowly in green.
2
Remote:
Open the battery cover (page 10),
then use an object with a thin tip,
press and hold
M
N
until the
LED indicator blinks slowly in
green (page 8).
R
When registration is complete,
the hub sounds one long beep.
Note:
R
To cancel without registering the
remote, press
M
N
on the hub and
on the remote again.
R
If registration fails, the hub sounds
several short beeps.
Using the app
When you register the remote by using
the
[Home Network]
app, you can
assign a name to your devices. For
more information, refer to the User’s
Guide (page 12).
Wireless
communication
range
The wireless communication range of
each device in the system from the hub
is approximately 50 m (160 feet)
indoors and approximately 300 m
(1,000 feet) outdoors. Wireless
communication may be unreliable
when the following obstacles are
located between the hub and other
devices.
R
Metal doors or screens
R
Walls containing aluminum-sheet
insulation
R
Walls made of concrete or
corrugated iron
R
Double-pane glass windows
R
Multiple walls
R
When using each device on
separate floors or in different
buildings
For assistance, please visit http://shop.panasonic.com/support
11
Setup
HNK102_(en_en_)_0616_ver.021.pdf 11
2015/06/16 18:14:14
