Indicator
Status
Red, blinking
Remote is out of
range of the hub, or
could not
communicate with
the hub
Green,
blinking slowly
Registration mode
(you pressed and
held
M
N
)
Repeating
pattern of
blinking green
and blinking
red
Low battery
*1 The LED lights for about 2
seconds after a button is pressed,
then turns off. If the LED indicator
does not light when you press a
button, the battery must be
replaced.
*2 The LED indicator does not
indicate remote’s status if the
remote has not been registered
(page 11).
Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the battery
The remote is battery powered.
3
Registration
Required only if the remote was
purchased separately (i.e., not as
part of a bundle).
4
Confirm the usage area
Read the information in this
document to confirm that the
desired usage area is suitable to
proper operation.
For assistance, please visit http://shop.panasonic.com/support
9
Setup
HNK102_(en_en_)_0616_ver.021.pdf 9
2015/06/16 18:14:14