Part names and
functions
A
B
D
E
F
C
Horn
Strobe light
Flashes when the siren is
sounding.
LED indicator
M
HIGH
N
/
M
LOW
N
Used to adjust the siren’s volume
(page 12).
Rear cover
M
N
Used to register the siren to the
hub.
LED indicator
You can use the LED indicator to
confirm the siren’s status.
Indicator
Status
Green, lit
Normal operation
Red,
blinking
slowly
Siren is not registered
to a hub
Red,
blinking
Siren is out of range of
the hub
Red,
blinking
quickly
Alarm system was
triggered
Green,
blinking
slowly
Registration mode
(You pressed and held
M
N
)
Off
No power
Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Registration
Required only if the siren was
purchased separately (i.e., not as
part of a bundle).
3
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
For assistance, please visit http://shop.panasonic.com/support
7
Setup
HNS105_(en_en)_0206_ver.111.pdf 7
2017/02/06 12:06:44
Summary of Contents for KX-HNS105
