2.4 Selecting the operation mode
(Scan/Copy/Fax)
You can select the desired mode by pressing one of the
following buttons.
–
M
Scan
N
: Select this mode when using the unit as a
–
M
Copy
N
: Select this mode when using the unit as a
–
M
Fax
N
: Select this mode when using the unit as a fax
Note:
R
The default operation mode is the copy mode.
R
You can change the default operation mode (feature
#463 on page 59) and the timer before returning to
the default operation mode (feature #464 on
page 59).
2.5 Setting the original
2.5.1 Using the scanner glass
A
B
1
Open the document cover (
A
).
2
Place the document FACE DOWN on the scanner
glass (
B
), aligning the top left of the document with
the corner where the mark is positioned.
3
Close the document cover.
Note:
R
Confirm that there are no documents in the automatic
document feeder.
R
Place the original onto the scanner glass gently. To
avoid malfunction, do not press down too firmly.
R
If the original is a thick book, do not close the
document cover.
R
Confirm that any ink, paste or correction fluid has
dried completely.
R
Effective scanning area is shown by the shaded area:
Effective scanning area
208 mm
289 mm
4 mm
4 mm
4 mm
4 mm
19
2. Preparation
