1.26.3 Call Charge Services
Description
The PBX receives a call charge signal during or after a conversation with an outside party. The call charge
information is shown on the telephone display and SMDR.
1.
Call Charge Signal Services
The type of call charge service that is used by the PBX is decided by the type of signal received from the
telephone company. The type of call charge signal received from the telephone company depends on the
trunk of the outgoing call. The services for each available trunk type are as follows:
Trunk
Service
Analogue trunk
ISDN line
Advice of Charge (AOC) (
®
1.21.1.3 Advice of Charge (AOC))
E1 line
Meter Pulse
*1
When the pay tone service is used, pay tone type (12 kHz/16 kHz) should be selected.
2.
Call Charge Display
–
Up to eight digits including a decimal (e.g., 12345.78)
–
The decimal point position (the number of significant decimal digits) for currency is programmable.
–
Up to three currency characters are programmable. (e.g., EUR or for Euro).
–
Through PC programming, you can select whether the currency characters or symbol are placed in
front of or behind the call charge. (e.g., 45.12 or 45.12 )
3.
Margin/Tax Rate Assignment
It is possible to add a margin and a tax to the call charges. The call charge rate per meter indication is
programmable on a trunk group basis.
[Calculation Method]
The margin or tax rate must consist of four digits, two digits before and after the decimal (xx.xx%). The
calculation method used by the PBX varies, depending on whether the telephone company sends the meter
indication or the actual call charge.
a.
Call charge with tax and margin in meter indication:
[Meter indication received from the telephone company] [Call Charge Rate] [1 Tax Rate]
[1 – Margin Rate]
b.
Call charge with tax and margin in charge:
[Charge received from the telephone company] [1 Tax Rate]
[1 – Margin Rate]
The calculation result is rounded up to the least significant decimal digit.
4.
Total Call Charge
–
A PT user can show the total call charges on the display.
–
The call charge is totalled on an extension, trunk, or verification code basis.
–
When a verification code is used, the call is charged on the verification code and not the extension that
the call was made on.
5.
Budget Management
It is possible to limit telephone usage to a preprogrammed budget on each extension or verification code.
For example, an extension in a rented office has a prepaid limit for telephone usage. If the amount of the
call charge reaches the limit, the extension user cannot make further trunk calls. An extension assigned
as the manager may increase the limit or clear the previous call charge (
®
302
Feature Guide
1.26.3 Call Charge Services
Summary of Contents for KX-NCP500
