1.15 Conference Group Call Features
1.15.1 Conference Group Call
Description
Conference group calling allows you to call a pre-determined group (conference group) of parties
simultaneously. Each party that answers the call joins the conference.
A PT user can call a conference group of up to 7 parties to establish a conference call, for a maximum of 8
participants. During a conference group call, the caller can restrict the ability of other members to speak.
Broadcast Mode
When Broadcast Mode is enabled through system programming, a PT user can call a conference group of up
to 31 call members to make a voice announcement. Members can listen to the announcement by answering
the call.
During the announcement, the voices of members will not be heard. However, the caller can allow up to 7
specific members to speak, making a conference call. This conversation can be heard by the other members.
Conference Group Call Control
During a conference group call, the caller can restrict or allow members’ ability to speak, and can remove
members from the call using the following buttons. These buttons will function irrelevant of the Conference
Group Call mode. Pressing the other buttons during the conversation will be ignored.
Note
The operation of these buttons during a conference group call is different from the operations for the
Conference feature (
®
Button
Function
DSS
Disables or enables the corresponding member's ability to speak.
CONF (Conference)
Establishes a conversation with the current members in the order
assigned in the conference group. Pressing this button again will add
the next available member in the group to the conversation.
TRANSFER
Removes the member who joined the conversation last. The member
can still listen to the announcement.
FLASH/RECALL (Flash/Recall
mode)
Removes the member who joined the conversation last. The member
will be disconnected from the conference group call and hear a
reorder tone.
SP-PHONE
Enables a hands-free conversation.
A member extension can inform the caller that he wants to speak or join the conversation by sending a
notification. The caller will hear a notification tone and the requesting extension’s information will be shown on
the display for five seconds.
Conference Groups
Eight conference groups can be programmed, and a maximum of 7 members (31 members in Broadcast Mode)
can be assigned to each group. The available destinations as members of the conference group are as follows:
Destination
Availability
Wired Extension (PT/SLT/SIP Extension/ISDN Extension/T1-OPX)
ü
180
Feature Guide
1.15.1 Conference Group Call
Summary of Contents for KX-NCP500
