5.5.3 Programming the Network Settings
For successful operation of a VoIP network using the V-IPGW4 card, network settings for the PBX at each
location must be programmed appropriately. For a detailed discussion of related features, refer to the Feature
Guide.
This section details the procedure to programme the network settings for the local PBX. After the programming
for the local PBX has been done, repeat the procedure for the remote PBX with the appropriate setting values.
The following procedures describe the process of programming the network settings for each numbering
method.
Programming for the PBX Code Method
1.
a.
Click
Setup
®
PBX Configuration
®
CO &
Incoming Call
.
b.
Click
CO Line Settings
.
c.
Type the
CO Name
and assign an unused
Trunk
Group Number
to be used for all IP trunks.
d.
Click
OK
.
2.
Note
Before changing Numbering Plan settings, when a
V-SIPEXT8 card or V-UTEXT8 card is installed,
change the status of the card(s) to OUS.
a.
Click
Setup
®
PBX Configuration
®
System
.
b.
Click
Numbering Plan
.
c.
Click
Main
.
d.
Click the
Features
tab.
e.
In the
TIE Line Access
cell, type the dialling
number.
f.
Click
OK
.
3.
a.
Click
Setup
®
PBX Configuration
®
Private
Network
.
b.
Click
TIE Table
.
c.
In the
Own PBX Code
cell, type the PBX code of the
local PBX in the network.
d.
In the first unused
Leading Number
cell, type the
PBX code of the remote PBX in the network.
e.
In the corresponding
Trunk Group
list, select the
number of the trunk group to be used when making
calls.
f.
If it is necessary to add number(s) to the input
number, enter the number(s) to be added in the
desired
Added Number
cell.
If it is necessary to delete number(s) from the input
number, enter the number(s) to be deleted in the
desired
Removed Number of Digits
cell.
g.
Click
OK
.
Installation Manual
175
5.5.3 Programming the Network Settings
Summary of Contents for KX-NS300
