Panasonic KX-NS300 Installation Manual Download

Page: 18 / 300

•

The plug of power supply cordset is used as the main disconnect device. Ensure that the AC outlet is
located near the equipment and is easily accessible.

•

Slots and openings in the front, back and bottom of the cabinet are provided for ventilation; to protect it
from overheating, these openings must not be blocked or covered. The openings should never be blocked
by placing the product on a bed, sofa, rug, or other similar surface while in use. The product should never
be placed near or over a radiator or other heat source. This product should not be placed in a sealed
environment unless proper ventilation is provided.

•

Make sure that the surface behind the PBX is flat and free of obstacles, so that the openings on the back
of the PBX will not be blocked.

•

When this product is no longer in use, make sure to detach it from the rack or wall.

•

Use only the AC power cord included with the PBX. A certified power supply cord has to be used with this
equipment. The relevant national installation and/or equipment regulations shall be considered. A certified
power supply cord not lighter than ordinary polyvinyl chloride flexible cord according to IEC 60227
(designation H05VV-F 3G 0.75 mm²) shall be used.

•

When the PBX is mounted on a 19-inch rack, make sure that the installation of the unit does not cause the
temperature of the rack to exceed its limit.

•

Make sure to install all necessary optional service cards in the PBX before performing the wall mounting
procedure. If it is necessary to install or remove a card, make sure to detach the PBX from the wall before
installing or removing the card.

•

When driving the screws into the wall, be careful to avoid touching any metal laths, wire laths or plates in
the wall.

•

When opening the top cover, the power switch must be turned off.

•

For safety reasons, close the top cover and tighten the screws before operating the PBX.

•

If the PBX is not installed properly using the securing correct methods, the PBX may fall causing serious
damage.

•

Performing surge protection is essential. Make sure to follow the instructions in "4.2.11 Surge Protector
Installation".

•

It is strongly recommended to use SSL encrypted communication when the PC is accessing the PBX via
the Internet. To use SSL encryption, routers must have a port set up for https communication.

•

Avoid using the same AC outlet for computers and other office equipment, as noise generated by such
equipment may hamper system performance or interrupt the system.

•

Unplug the system from its power source when wiring, and plug the system back in only after all wiring is
completed.

•

Trunks should be installed with surge protectors. For details, refer to "4.2.11 Surge Protector
Installation".

•

When installing or removing the optional service cards, the power switch must be turned off.

•

For earthing wire, green-and-yellow insulation is required, and the cross-sectional area of the conductor
must be more than 0.75 mm

or 18 AWG.

•

When connecting a PRI30/E1 card to the trunk, connect through an NT1; do not connect to the U interface
of the trunk directly.

•

PRI ports of PRI30/E1 card is SELV ports and should only be connected to SELV services.

•

The MOH port and Pager port are SELV ports and should only be connected to approved SELV devices,
or via a Line Isolation Unit with a Telecommunications Compliance Label.

WARNING

This is a class A product. In a domestic environment this product may cause radio interference in which
case the user may be required to take adequate measures.

Installation Manual

1.1 For Your Safety