SD Memory Cards
The KX-NT400 allows you to back up and restore your
personal contacts and other settings using a CSV file.
See "Data Maintenance (Page 174)" for details.
Important Information
To prevent data corruption or damage to the SD
memory card, which may also affect the performance
of the KX-NT400, keep the following in mind.
•
Do not remove the SD memory card or Ethernet
cable while backing up, formatting, or while
restoring data for the card.
•
Do not move or bump the KX-NT400 during backing
up, formatting, or while restoring data on the SD
memory card.
•
Do not touch the contacts on the bottom of the SD
memory card.
•
To prevent damage to the KX-NT400, do not insert
any memory card other than a compatible SD
memory card.
Compatible SD Memory Cards
The KX-NT400 supports the following SD memory
cards.
•
SD, miniSD, and microSD memory cards
–
Use a miniSD or microSD adaptor when using
miniSD or microSD memory cards,
respectively, and always insert the miniSD or
microSD memory card into the adaptor before
inserting the adaptor into the KX-NT400.
•
Cards with a capacity of 32 MB to 2 GB
•
Class 2, Class 4, and Class 6 cards
Note
•
The KX-NT400 does not support SD
High-Capacity (SDHC), miniSDHC, and
microSDHC memory cards.
Inserting and Removing SD
Memory Cards
Insert the SD memory card as shown below.
To remove the card, gently push the card in to release
it, and then remove the card.
Write Protection (LOCK)
SD memory cards can be locked to prevent formatting,
deleting, and recording. To lock an SD memory card,
slide the switch on the side of the card to the "LOCK"
position.
WRITE
LOCK
190
Operating Instructions
Appendix
