Link to mobile settings
Selecting which unit receives
mobile calls
You can select which unit rings and receives
calls for a mobile line. When
“
All
”
is
selected, the handset and the base unit ring.
1
For mobile 1:
M
N
(right soft key)
#6271
For mobile 2:
M
N
(right soft key)
#6272
2
MbN
: Select the handset or
“
All
”
.
a
M
OK
N
3
M
N
Note:
R
When you select the handset to receive
calls for a mobile line, the base unit can
answer the calls even though it does not
ring. However, you can make the base unit
ring by adjusting the base unit ringer
volume (page 36).
R
When you change to
“
All
”
from other
setting, the base unit ringer volume also
returns to the lowest level even if the ringer
volume was changed.
R
The units selected with this setting have the
SMS alert feature (page 53) applied to
them.
Ring as mobile mode
Once this feature is turned on, the handset
and base unit ring using the same ringer tone
as your mobile phone.
The following settings are available:
–
“
Off
”
: Turn this feature off to use the
ringer tones of the handset and base unit.
–
“
On
”
(default): The handset and base unit
use your mobile phone’s ringer tone.
Important:
R
To use this feature, your mobile phone
must support Bluetooth in-band ringtone.
Refer to your mobile phone’s operating
instructions.
1
For mobile 1:
M
N
(right soft key)
#6141
For mobile 2:
M
N
(right soft key)
#6142
2
MbN
: Select the desired setting.
3
M
OK
N
a
M
N
Note:
R
The units use the preset ringer tones
(page 36) instead of your mobile phone’s
ringer tone when a mobile call is being
received if:
– your mobile phone is in do not disturb
mode (depending on your mobile phone).
– the base unit is in use.
To use the handset ringer tone
instead of your mobile phone’s ringer
tone
Select
“
Off
”
in step 2, “Ring as mobile
mode”, page 21.
To change the handset ringer tone for a
mobile line, see page 36.
Auto connection to the Bluetooth
devices (mobile phones)
After pairing, your Bluetooth devices are
connected to the base unit. If you move the
Bluetooth devices out of base unit range, the
Bluetooth devices are disconnected from the
base unit. This feature allows the base unit to
try to reconnect the mobile phone at regular
intervals when it returns within base unit
range. You can set the interval. The default
setting is
“
1 min
”
.
Important:
R
When you are using a mobile line, the base
unit loses its connection from other
Bluetooth devices (mobile phone). To
automatically resume the connection to
mobile phones, leave the auto connection
on.
R
Some mobile phones lose connection after
usage, please check the specifications of
your mobile phone for more details.
1
M
N
(right soft key)
#632
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
21
Link to Mobile
PRL250EX1(en)1006_ver011.pdf 21
2014/10/06 15:04:34
