Blocking incoming calls that
have no phone number
You can reject calls when no phone number is
provided, such as private callers.
1
M
N
(right soft key)
#240
2
MbN
: Select the desired setting.
a
M
OK
N
a
M
N
Note:
R
When the unit receives a mobile call
without a phone number, the call may not
be rejected.
Viewing/editing/erasing call
block numbers
1
M
N
(right soft key)
#217
2
MbN
:
“
Single Number
”
or
“
Range of
Numbers
”
a
M
OK
N
3
MbN
: Select the desired entry.
R
To exit, press
M
N
.
4
To edit a number:
M
N
a
Edit the number.
a
M
OK
N
a
M
N
To erase a number:
M
N
a
MbN
:
“
Yes
”
a
M
OK
N
a
M
N
Note:
R
When editing, press the desired dial key to
add,
M
C
N
to erase.
Erasing all call block numbers
1
M
N
(right soft key)
#217
2
MbN
:
“
Single Number
”
or
“
Range of
Numbers
”
a
M
OK
N
3
M
N
a
MbN
:
“
Erase All
”
a
M
OK
N
4
MbN
:
“
Yes
”
a
M
OK
N
5
MbN
:
“
Yes
”
a
M
OK
N
a
M
N
Baby monitor
This feature allows you to listen in on a room
where another handset is located, allowing
you to easily monitor from different areas of
the house or place. The monitored handset
(placed in a baby’s room, for example) will
automatically call the monitoring handset or
the phone number stored when it detects
sound.
Important:
R
You should perform a test run of the baby
monitor procedure to ensure that the baby
monitor feature is set correctly. For
example, test its sensitivity. Check the
connection if you are diverting the baby
monitor to an outside line.
R
This feature should not be used as a
substitute for a medical or caregiver’s
supervision. It is the caregiver’s
responsibility to stay close enough to
handle any eventuality.
R
If
“
Mobile Line Only Mode
”
is set, the
unit cannot make a call to the stored phone
number for baby monitor.
Note:
R
If the unit is connected to a PBX system,
you cannot set the baby monitor.
R
During the monitoring mode, battery
consumption is faster than usual. We
recommend leaving the monitored handset
on the base unit or charger.
R
The monitored handset never rings during
the monitoring mode.
If the monitored handset is on the base
unit, the base unit ringer sounds. Turn off
the base unit ringer volume to not sound
the ringer (page 36, 38).
Setting the baby monitor
Perform the setting operation with the handset
to be monitored (for example, the handset
placed in a baby’s room).
To monitor with a handset
The internal baby monitor feature is only
available between handsets.
44
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
Programming
PRL250EX1(en)1006_ver011.pdf 44
2014/10/06 15:04:35
