5
Pairing a Bluetooth mobile phone
1
Handset:
For mobile 1:
{
6
}
(right soft key)
(
6241
For mobile 2:
{
6
}
(right soft key)
(
6242
L
After the corresponding indicator (
1
/
2
) on the base unit starts flashing, the rest of the
procedure must be completed within 5 minutes.
2
Your mobile phone:
While the corresponding indicator (
1
/
2
) is flashing, follow the instructions of your mobile
phone to enter the pairing mode.
L
Depending on your mobile phone, it may ask you to enter the Bluetooth PIN (default:
“
0000
”
). If your mobile phone shows PassKey confirmation on its display, follow the
directions to proceed.
3
Handset:
Wait until a long beep sounds.
L
It may take more than 10 seconds to complete pairing.
L
When the corresponding indicator (
1
/
2
) lights up, the mobile phone is connected to the
base unit. You are ready to make mobile calls.
4
{
m
}
Note:
L
Make sure that your mobile phone is set to connect to this product automatically. Refer to your
mobile phone’s operating instructions.
Base unit:
1
/
2
indicators
Status
Meaning
On
A mobile phone is connected. Ready to make/receive mobile calls.
Flashing
−
The mobile line is in use.
−
Phonebook entries are being copied from a mobile phone.
−
The base unit is searching for the paired mobile phone.
−
The base unit is pairing a mobile phone.
−
A mobile call is put on hold.
Flashing rapidly
A mobile call is being received.
Light off
−
A mobile phone is not paired to the base unit.
−
A mobile phone is not connected to the base unit.
Handset: Link to mobile display items
5
A mobile line is in use.
L
When flashing: The mobile call is put on hold.
L
When flashing rapidly: A mobile call is being received.
A mobile phone is connected.
*1
Ready to make/receive mobile calls.
L
When turned off: A mobile phone is not connected to the base unit.
*1 Corresponding mobile line(s) is(are) indicated next to the item.
34
−
A mobile call is being done on that line.
−
The mobile line is selected for the setting.
Link to mobile
PRL250EX1_PRD250EX1(4lang)_QG.book Page 5 Monday, October 20, 2014 7:47 PM
