Battery installation/Battery charging
When the language selection is displayed after installing the batteries for the first
time, you can select your desired language.
MbN
: Select the desired setting.
a
M
SAVE
N
a
M
OFF
N
Important:
R
Use the supplied rechargeable batteries. For replacement, we recommend using
the Panasonic rechargeable batteries noted in the base unit’s operating
instructions.
R
USE ONLY rechargeable Ni-MH batteries AAA (R03) size (
1
).
R
Do NOT use Alkaline/Manganese/Ni-Cd batteries.
R
Confirm correct polarities (
,
).
Charge for about 7 hours.
R
Confirm
“
Charging
”
is displayed (
2
).
R
When the batteries are fully charged,
“
Fully charged
”
is displayed.
1
2
Note:
R
If the batteries are fully charged, but the operating time seems to be shorter,
clean the battery ends (
,
) and the charge contacts with a dry cloth and
charge again.
Registering a handset to a base unit
1
Base unit:
Press and hold
M
N
for about 5 seconds.
R
If all registered handsets start ringing, press
M
N
again to stop, then repeat
this step.
2
Handset:
Place the handset on the base unit or charger, then wait until a long beep
sounds and
is displayed.
3
Installation
PRLA20C_(en-en)_0110_ver.030.pdf 3
2014/01/10 21:27:19
Summary of Contents for KX-PRLA20C
