2.2 PT Programming—Procedures
38
Programming Manual
Conditions
•
The numbers of outside (CO) line ports that do not have lines connected should be set to "Not
connect". The PBX seizes the highest available outside (CO) line number when selecting an idle
outside (CO) line automatically. If an unconnected outside (CO) line number is set to "Connect"
and is numbered higher than any connected outside (CO) line number, the PBX will try to seize the
unconnected outside (CO) line.
Feature Manual References
1.1.71 Line Access, Outside (CO) Line—SUMMARY
1.1.76 Line Preference—Outgoing
[401] Dial Mode
Selects the type of signal used to dial out using an outside (CO) line.
Programming Manual References
[402] Pulse Speed
Feature Manual References
1.1.39 Dial Type Selection
[402] Pulse Speed
Selects the speed at which pulse signals are sent to the outside (CO) lines for which Dial Mode in [401] Dial
Mode is set to "Pulse" or "Call Blocking".
Programming Manual References
[401] Dial Mode
Feature Manual References
1.1.39 Dial Type Selection
4
0
1
NEXT
CO line no.
name*
STORE
END
(1…8/ )
SELECT
SELECT
NEXT
PREV
or
To continue
To continue
( DTMF/Pulse/
Call Block mode)
4
0
2
NEXT
CO line no.
name*
STORE
END
(1…8/ )
SELECT
SELECT
NEXT
PREV
or
To continue
To continue
( Low Speed: 10 pps/
High Speed: 20 pps)
Summary of Contents for KX-TA82483 - Expansion Cards
