2.8 [2] System
122
PC Programming Manual
SVM—Dial Tone Continuous Time
Specifies the length of time that dial tone 3 is heard after all messages stored by the SVM feature for
an extension are finished playing.
Default
5 s
Value Range
1–60 s
Maintenance Console Location
2.8.4 [2-3] Timers & Counters
Programming Manual References
2.10.7 [4-1-6] Wired Extension—Simplified Voice Message
2.10.12 [4-2-4] Portable Station—Simplified Voice Message
Feature Manual References
1.16.5 SVM (Simplified Voice Message)
2.8.5
[2-4] Week Table
A specific time mode (day, night, lunch, or break) can be selected for operation depending on the time
of day. The time mode can be switched either automatically or manually. Select the desired switching
mode from the
Time Service Switching Mode
option.
Time Table numbers correspond to tenant numbers (for example, Tenant 1 uses Time Table 1). Select
the desired Time Table from the
Time Table No.
list.
When in Automatic Switching mode, the time modes of the tenant are switched as programmed in the
corresponding Time Table. Manual switching is possible only from an authorized extension
(determined by COS).
•
To adjust the currently displayed Time Table, click and drag the divisions between two time
periods.
•
To program the time blocks of the currently displayed Time Table, including adding or
deleting time blocks, click
Time Setting
.
2.8.6
[2-4] Week Table—Time Setting
The start times of 4 different time blocks can be programmed for each day of the week, for the
selected Time Table, as well as the start and end times of up to 3 break periods.
1. Day/Lunch/Night—Day1 Start, Lunch Start, Day2 Start, Night Start—
Setting
Enables the setting of the start time for each time block.
