Multi-unit Operation
32
Cancelling a base unit
A handset can be registered to a maximum
of 4 base units. A handset can cancel a base
unit that it is registered to. This allows the
handset to “forget” the base unit.
1
Press
{j
/OK
}
.
2
Select
“
Handset Setup
”
, then press
{>}
.
3
Select
“
Registration
”
, then press
{>}
.
4
Enter
“
335
”
.
5
Select
“
Cancel Base
”
, then press
{>}
.
6
Enter
“
0000
”
(default handset PIN).
L
If you changed the PIN, enter it (page
21).
7
Select the base unit(s) you want to
cancel, by pressing the desired base unit
number.
L
The selected base unit number(s) will
flash.
L
To cancel a selected base unit
number, press the number again. The
number will stop flashing.
8
Press
{j
/OK
}
.
9
Select
“
Yes
”
, then press
{>}
.
10
Press
{ih}
.
Note:
L
To register the handset to another base
unit or to the same base unit again, see
manual registration (page 31).
Increasing the range of the base
unit
You can increase the range of the base unit
by using a DECT repeater. Please use only
the Panasonic DECT repeater noted on
page 4. Consult your Panasonic dealer for
details.
Important:
L
Before registering the repeater to this
base unit, you must turn the repeater
mode on.
Turning the repeater mode on/off
1
Press
{j
/OK
}
.
2
Select
“
Base Unit Setup
”
, then
press
{>}
.
3
Enter
“
0000
”
(default base unit PIN).
L
If you changed the PIN, enter it (page
26).
4
Select
“
Other Options
”
, then press
{>}
.
5
Select
“
Repeater Mode
”
, then press
{>}
.
6
Select
“
On
”
or
“
Off
”
, then press
{>}
.
7
Press
{ih}
.
Note:
L
After turning repeater mode on/off, you
will not be able to make or receive calls for
a few moments.
Intercom between
handsets
Intercom calls can be made between
handsets in the same radio cell, but not
between handsets in different radio cells.
Example:
When handset 1 calls handset 2
1
Handset 1:
Press
{
INT
}
and
{
2
}
(desired handset
number).
2
Handset 2:
Press
{C}
or
{s}
to answer.
3
When finished talking, press
{ih}
.
TCD200FX(e-e).book Page 32 Monday, February 7, 2005 1:19 PM
