30
Multi-unit Operation
Multi-unit Operation
Operating additional units
Additional handsets
Up to 6 handsets can be registered to a
single base unit. Additional handsets will
give you the freedom to, for example, have
an intercom call with another handset while
a third handset is on an outside call. See
page 3 for information on ordering additional
handsets.
Additional base units
Handsets can be registered to up to 4 base
units, allowing you to add additional base
units and extend the area in which your
handset(s) can be used. If a handset moves
out of range of its base unit when “
AUTO
” is
selected on base unit selection (page 31), it
will look for another base unit to make or
receive calls. A base unit and the handsets
it communicates with is called a “radio cell”.
Note:
L
Calls will be disconnected when the
handset moves from one radio cell to
another.
L
Intercom calls and call transfers are only
possible between handsets in the same
radio cell.
Registering a handset to a
base unit
To register an additional handset to a
base unit (easy registration)
The included handset and base unit are
preregistered. After purchasing an
additional handset, register it to the base
unit using the following method.
1
Lift the additional handset and press
{ih}
.
2
Press and hold
{x}
on the left side of the
base unit for about 5 seconds, until the
registration tone sounds.
3
Place the additional handset on the base
unit. The registration tone continues to
sound. With the handset still on the base
unit, wait until a confirmation tone sounds
and
w
stops flashing.
Note:
L
If an error tone sounds, or if
w
is still
flashing, register the handset manually
(manual registration).
L
If all registered handsets start ringing in
step 2, press
{x}
to stop, then start again.
L
Charge the batteries of your additional
handset for about 7 hours before initial
use.
L
This registration method cannot be used
for handsets that have already been
registered to a base unit. Register the
handset manually (page 30).
To register a handset to an additional
base unit (manual registration)
You can register a handset to a base unit
manually using the following method.
1
Press
{j}
.
2
Press
{v}
repeatedly to display
“
SETTING HS
”, then press
{>}
.
3
Press
{v}
repeatedly to display
“
REGISTRATION
”, then press
{>}
.
4
Press
{v}
repeatedly to display
“
REGISTER HS
”, then press
{>}
.
5
Press and hold
{x}
on the left side of the
base unit for about 5 seconds, until the
registration tone sounds.
L
After pressing
{x}
, the rest of the
procedure must be completed within 1
minute.
6
Press
{v}
repeatedly to select a base
unit number, then press
{>}
.
7
Wait until “
BS PIN
” is displayed, then
enter “
0000
” (default base unit PIN).
TCD440̲445NZ(E).book Page 30 Monday, March 29, 2004 9:02 AM
