4.3
System Programming
VM Command DTMF Set
(contd.)
114
4-48
System Programming
Selection
• LV-MSG / GETMSG / AA-SVC / VM-SVC
• DTMF signal number: 16 digits (max.)
Default
LV-MSG – H; GETMSG –
H; AA-SVC – #8 ; VM-SVC – #6
Programming
1.
Enter 114.
Display: 114 VM DTMF CMD
2.
Press NEXT to program the LV-MSG command.
To program another command, keep pressing NEXT until the desired
command is displayed.
Display example: LV-MSG:H
3.
Enter a DTMF signal number.
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and enter the new number.
4.
Press STORE.
5.
To program another selection, keep pressing NEXT or PREV
until the desired selection is displayed.
6.
Repeat steps 3 through 5.
7.
Press END.
Conditions
• A command signal number can have a maximum of 16 digits,
consisting of 0 through 9,
, #, FLASH or FLASH/RCL and
PAUSE.
• The FLASH or FLASH/RCL button is available only for LV-MSG and
GETMSG commands to store “H” which means “Home Position”.
• If “H” is stored for “LV-MSG”, a mailbox number programmed in
program [609] “Voice Mail Access Codes” or an extension number will
be sent to the VM port (Follow On ID function). If certain codes are
required before and after the ID code, insert “H” between the codes, as
“aaaHbbb”. If nothing is stored, it will operate as “H”.
• If “
H” is stored for “GETMSG”, a mailbox number programmed in
program [609] “Voice Mail Access Codes” or an extension number will
be sent to the port succeeding the “
”.
Feature References
Section 3, Features
Voice Mail Integration
