4-10
System Programming
4.1.3
Entering Characters
1.
Enter 6.
2.
Press Soft 1 (
M
).
3.
Enter 4.
4.
Press SHIFT.
5.
Press Soft 3 (
i
).
6.
Enter 5.
7.
Press Soft 2 (
k
).
8.
Enter 3.
The display shows:
6
M N O
M
M N O
M4
G H I
M4
g h i
Mi
g h i
Mi5
j k l
Mik
j k l
Mik3
d e f
To select a desired character, press the key which has.
For example, to select the letter “M”:
Select either of the following two methods:
(1) Using the SHIFT and Soft buttons
* See Combination Table 1.
1. Press 6. (“M” belongs to “6.”)
• The Function Line shows: M N O
2. Press the Soft 1 (M) button.
(Press SHIFT to display the lower case of the above letters.)
(2) Using the SELECT button
* See Combination Table 2.
1. Press 6. (“M” belongs to “6.”)
2. Press the SELECT button once.
• Pressing the SELECT button an appropriate number of
times gives you the desired letter. Pressing SELECT
twice gives the letter “m,” pressing three times gives “N,”
and so on.
Example of entering characters: to enter “Mike”:
Using method (1)
* See Combination Table 1.