6.1
Troubleshooting
6.1.4
Using Reset Button
If the system does not operate properly, use the Reset Button.
(If Master and Slave Systems are in operation by System
Connection*, reset both systems.)
Before using the Reset Button, try the system feature again to
confirm whether there definitely is a problem or not.
Notes:
(a) When the System Clear Switch is set to “NORMAL,” pressing
the Reset Button causes the following:
1. Camp-on is cleared.
2. Calls on Hold are terminated.
3. Calls on Exclusive Hold are terminated.
4. Calls in progress are terminated.
5. Call Park is cleared.
Other data stored in memory except the above are not cleared.
(b) When the System Clear Switch is set to the “CLEAR” position,
you must press the Reset Button with caution, because all data
stored in memory will be cleared by the following operation:
pressing the Reset Button and setting the System Clear Switch
to the “ NORMAL” position while the Power Indicator is
flashing.
*: Available for KX-TD1232 only.
Troubleshooting
6-5
PROBLEM
During system connection*
operation, originating an
intercom/outside call from
a system to the other
system is not possible.
Originating an outside call,
Call Transfer, or Conference
cannot be performed.
PROBABLE CAUSE
Interface between the
systems is disconnected.
The corresponding CO
button does not exist on the
proprietary telephone.
POSSIBLE SOLUTION
Connect the interface between the
systems and press the Reset Button
on both systems.
Program the CO button. See
Section 4.2 [005] “Flexible CO
Button Assignment.”
