Physical Installation
46
Installation Manual
3.4
Connect the Network Cable
A standard 10BaseT cable with an RJ45 connector is used to interconnect the KX-TDA0480
with a network device.
To install the Network connector cable:
1.
Insert the RJ45 connector into the KX-TDA0480 UPLINK port located on the unit's front
panel.
Uplink connector location
2.
Connect the other end of the 10BaseT cable to the remote LAN equipment (e.g., router,
Ethernet switch, or hub.)
When connecting the KX-TDA0480 directly to a router use a 10BaseT Cross/Rollover cable.
Use a 10baseT straight cable to connect the KX-TDA0480 to a hub or Ethernet switch.
IP Link Cable
(Straight Cable)
Router
Switching HUB
IP Network
Summary of Contents for KX-TDA0480
