Logical Installation
Installation Manual
67
Unit Setup Wizard 4 of 6
Use the Setup Wizard screen 4 to either accept the default Maintenance password or change
the Maintenance password.
The default Maintenance password is
mainte
typed in lower case characters. Be careful to
make a record of any new password that is entered at this time
*1
.
1.
If the default password is to be used, click on the
Use Default
check box and proceed to
step 5.
2.
If the Maintenance password is to be changed, select the
Password
field and type the new
password. To enhance security, an * (asterisk) symbol will be echoed in place of each
character typed.
WARNING
If a password is lost, it cannot be recovered. In the event of a lost password, contact your
maintenance staff, an service office, or an authorised agent.
3.
Select the
Confirm password
field and retype the new password. To enhance security, an
* (asterisk) symbol will again be echoed in place of each character typed.
4.
Click on the
Next
button when finished entering information or click on the
Cancel
button
to exit the Wizard and lose all changes.
*1
If the new password is lost, contact the Customer Support.
Summary of Contents for KX-TDA0480
