2.2 Programming
Programming Guide
29
3.
Click
ENTRY
.
A maximum of 16 hunt patterns can be created.
4.
Click
OK
.
You will see a confirmation screen.
Note
If your entry contains an invalid value, you will be prompted to correct your input. Enter
correct values for the parameters shown in red and try again.
5.
Confirm your entry and click
OK
.
To return to the previous screen, click
CANCEL
.
Parameter Descriptions
The parameters indicated with "
*
" must be changed while the VoIP Gateway Card is in the "STOP" status (see
"2.3.1 Status Control"). The changes do not have to be followed by a reboot to become effective.
Hunt Group
Hunt Pattern Entry
The parameters below are used to create hunt patterns.
For details, refer to "Detailed Explanations".
Parameter & Description
Default
Value Range
*
Port1–8
Assigns a hunt group to a VoIP gateway port.
For details, refer to "Detailed Explanations".
Hunt group 1
Hunt group 1 to 8
Parameter & Description
Default
Value Range
*
Hunt Pattern No.
Specifies the number for the hunt pattern to be created.
When changing the current settings of an existing hunt
pattern, first delete the hunt pattern and then re-create with
new values.
No default
1 to 16
*
Receive Leading Number
Specifies the leading digits in received numbers by which to
determine the hunt group to direct incoming calls.
For example, to direct incoming calls with numbers starting
with "9", specify the number "9" in this parameter. Likewise,
to direct incoming calls with numbers starting with "1", specify
the number "1".
However, if you want to direct incoming calls with numbers
starting with "950" and "951" to separate hunt groups, it is
necessary to make 2 hunt patterns with respective numbers,
"950" and "951".
No default
Max. 30 digits
