3.1.4 Customizing the Buttons
You can customize the flexible buttons and/or programmable feature (PF) buttons on PTs, Add-on Key
Modules, and PSs. They can then be used to make or receive outside calls or as feature buttons.
•
To enter the programming mode when using a PS, refer to "Operating Instructions" for PS.
•
The buttons in the table below can only be set on certain flexible buttons, as follows:
–
Flexible buttons on PTs/Add-on Key Modules/PSs: all buttons can be set.
–
Flexible buttons on DSS Consoles: all buttons except CTI and Primary Directory Number
(PDN) buttons can be set.
–
Programmable feature (PF) buttons: only the One-touch Dialing button can be set.
Press
PROGRAM
or
PAUSE
.
Press
PROGRAM
or
PAUSE
.
Press desired
flexible button.
To exit
To program
To enter the program mode
Follow
programming
input
.
To continue
programming
input
OR
PROGRAM
PAUSE
OR
PROGRAM
PAUSE
Press
ENTER
or
STORE
.
OR
AUTO DIAL
STORE
Button
Programming Input
Loop-CO (L-CO)
Group-CO (G-CO)
#
+ Outside line group no. (2 digits)
Single-CO (S-CO)
0
+ Outside line no. (3 digits)
Direct Station Selection
(DSS)
1
+ Extension no.
One-touch Dialing
*1
2
*²
+ Desired no. (max. 32 digits)
Incoming Call Distribution
Group (ICD Group)
3
0
+ Incoming call distribution group extension no. (+
#
+
delayed ringing time [0–7])
*4
Message
4
0
Message for Another
Extension
4
0
+ Extension no./Incoming call distribution group extension no.
Call Forwarding (FWD)/Do
Not Disturb (DND)—Both
calls
4
1
FWD/DND—Outside calls
4
2
FWD/DND—Intercom calls
4
3
Group FWD—Both calls
4
4
+ Incoming call distribution group extension no.
170
Operating Manual
Document Version 2008-10
3.1.4 Customizing the Buttons
Summary of Contents for KX-TDA50
