2.7 [1] Configuration
PC Programming Manual
213
Feature Manual References
None
OUS
Takes the port out of service. This enables a temporary non-use of the port, for example, for the
purpose of repair.
Default
Not applicable.
Value Range
Not applicable.
Maintenance Console Location
2.7.30 [1-1] Slot—DPH Port Command (KX-TDA50 only)
Programming Manual References
2.7.29 [1-1] Slot—DPH Card Property (KX-TDA50 only)
Feature Manual References
None
2.7.31 [1-2] Portable Station
Various portable station (PS) settings can be programmed. A maximum of 28 (with the KX-TDA50),
128 (with the KX-TDA100/KX-TDA200), 256 (with the KX-TDA600) or 512 (with the KX-TDA600 with
EMEC card installed) PSs can be registered.
Information on 32 PSs is displayed at a time. To display other PSs, click the applicable tab.
PS Registration and De-registration
A PS must be registered to the PBX by programming both the PBX and PS before it can be used.
Programming instructions of the PBX are given below; programming instructions of the PS are found
in the Installation Manual.
It is possible to de-register the PS later.
Registration
Follow the steps below to register the PS.
1.
Click
Registration
.
A dialog box will appear. Non-registered (available) extension numbers are displayed on the
left.
2.
Highlight numbers and click the right arrow to select them for registration. Click
Next
.
A screen will appear with information on the current PS extension number and index number
for programming.
3.
Register the relevant PS.
For details, refer to the Installation Manual.
