2.7 [1] Configuration
PC Programming Manual
219
Default
ISDN Standard mode
Value Range
ISDN Standard mode: The CCBS, CF, CT, and Centralized VM features are supported. DIL and DID
call distribution are available for the D channel.
T1-LCOT mode: DIL and DID call distribution are available for all 23B channels. The CCBS, CF, CT,
and Centralized VM features are not available in this mode.
Maintenance Console Location
2.7.32 [1-3] Option
Programming Manual References
None
Feature Manual References
1.13.14 Private Network Features—Centralized Voice Mail
1.4.6 DIL (Direct In Line)
1.4.5 DID (Direct Inward Dialing)
1.13.20 Private Network Features—QSIG—CF (Call Forwarding)
1.13.22 Private Network Features—QSIG—CT (Call Transfer)
1.13.19 Private Network Features—QSIG—CCBS (Completion of Calls to Busy Subscriber)
2.7.33 [1-4] Clock Priority (KX-TDA100/KX-TDA200/KX-TDA600)
Slot Number (KX-TDA100/KX-TDA200), Shelf-Slot Number (KX-TDA600)
Selects and prioritizes slot numbers for the PRI and T1 cards that are used to forward a clock pulse
from an external source to the PBX.
Obtain the master clock time from the outside line that the telephone company provides.
To change Clock Priority, follow the steps below:
1.
Assign a Clock Priority to each PRI and/or T1 card.
2.
Set the status of the present clock source card to "
OUS
", then "
INS
".
Note
If multiple PBXs are used to establish a private network (TIE line service, QSIG network, etc.)
without being connected through the telephone company, assign only one PBX as the clock
source on the network. That PBX should have a card connected to a telephone company line
selected as its clock source. All other PBXs should have cards connected to the network selected
as the clock source. This enables all PBXs on the network to synchronize their timing.
Default
None
Value Range
None, PRI23, T1
