2.16 [10] CO & Incoming Call
PC Programming Manual
659
Maintenance Console Location
2.16.5 [10-3] DID Table—Name Generate (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
2.16.3 [10-3] DID Table (KX-TDA100/KX-TDA200/KX-TDA600 only)
Feature Manual References
1.4.5 DID (Direct Inward Dialing)
2.16.6 [10-4] Miscellaneous
The Intercept Routing feature can activate when the destination of an incoming call is unavailable, or
when there is no destination for the call, to reroute the call to an alternate destination.
Intercept—Intercept Routing - DND (Destination sets DND)
Enables the Intercept Routing—DND feature to activate when the original destination is in DND
mode.
Default
Enable
Value Range
Disable (Busy Tone): Sends a busy tone to the caller. (However, a call through an LCOT/ELCOT or
T1 [LCOT/GCOT] card will ring at the original destination while the caller hears a ringback tone.)
Enable: Redirects the call to the intercept destination
Maintenance Console Location
2.16.6 [10-4] Miscellaneous
Programming Manual References
None
Feature Manual References
1.4.9 DND (Do Not Disturb)
1.9.11 Intercept Routing
Intercept—Routing to Operator - No Destination (Destination is not
programmed)
Enables the Intercept Routing—No Destination feature to activate when there is no destination for the
call. (The Intercept Routing—No Destination feature always works for calls through an LCOT/ELCOT
or T1 [LCOT/GCOT] card, even when this feature is disabled.)
Default
Enable
