7/17/2009
8
Revision 2
2-Subscriber Level Configuration Parameters
This section identifies the SIP service subscriber-specific parameters, including
registration and authentication. These settings must be unique for each account.
Provisioning a subscriber to register with Cbeyond allows calls to terminate to the
subscriber’s line. Registration requires that a unique address of record (AoR) is
provisioned on Cbeyond Application server cluster. A user name (SIP account) and a
password (Authentication Password) will be provided from Cbeyond to each
subscriber.
Step
Command
Purpose
Step 1
Set SIP Account<compulsory>.
The register user ID must correspond
with the line/port setting on Cbeyond
Step 2
Set Authentication ID
<compulsory>.
If the Authentication service is
configured on Cbeyond, these
parameters must be configured to
match the Cbeyond settings.
Step 3
Set Authentication Password
<compulsory>.
Specifies the password (compulsory).
4- NAT Traversal
Based on your network architecture you need to choose the proper method to perform the NAT
transversal.
If you have chosen the fixed IP address method and the WAN port of your SIP-GW card is
connected to the LAN side of your Broadband router, you have to Enable the NAT traversal and
specify the Fixed IP address of the Broadband Router.
Example ( SIP-GW WAN side IP address is Private IP address 192.168.10.100) and your SIP
account is authenticated over the Cbeyond Circuit IP address, Fixed IP address NAT traversal
has to be enabled
If the Authentication IP address is over the Private IP address of the WAN side of the SIP-GW
card, The NAT Traversal should be disabled.
