When using a DHCP server:
a.
Select
Enable
for the
DHCP Client
setting.
b.
Click
Apply
.
Note
The boxes will turn grey and the IP addresses will be assigned automatically after the PBX is reset.
When not using a DHCP server:
a.
Select
Disable
for the
DHCP Client
setting.
b.
In the
IP Address for IPCEMPR Card
box, type the IP address of the IPCEMPR card.
*1
c.
In the
IP Address for VoIP-DSP
box, type the IP address of the DSP16 or DSP64 card.
*2
d.
In the
Subnet Mask
box, type the subnet mask address of the network.
*3
e.
In the
Default Gateway
box, type the IP address of the default gateway.
*4
f.
Click
Apply
.
When using a DHCP server to obtain a DNS server IP address automatically:
a.
Select
DHCP
for the
DNS Server Address Method
setting.
b.
Click
Apply
.
Note
The boxes will turn grey and the IP addresses will be assigned automatically after the PBX is reset.
When not using a DHCP server to obtain a DNS server IP address automatically:
a.
Select
Manual
for the
DNS Server Address Method
setting.
b.
In the
Manual Preferred DNS Server IP Address
box, type the IP address of the preferred DNS
server.
c.
In the
Manual Alternate DNS Server IP Address
box, type the IP address of the alternate DNS
server.
d.
Click
Apply
.
The system menu appears. You may now begin programming the PBX.
Notice
•
Do not change the IP addresses of the IPCEMPR and DSP cards once IP telephones are
registered to the PBX using these IP addresses.
The IP telephones will not operate properly if these IP addresses are changed.
•
A DHCP server must be able to use a "client identifier" option specified by RFC 2131.
•
The PBX will not start properly if the IP addresses cannot be assigned automatically by the
DHCP server when DHCP Client is set to Enable. In this case, you need to consult your
network administrator because the DHCP server on your network may not be running or a
network failure may have occurred. If the DHCP server cannot be available, change the DHCP
Client setting to Disable and set fixed IP addresses, then restart the PBX.
To change the DHCP Client setting, connect the PC with an RS-232C cross cable or Ethernet
straight cable. When connecting the PC with an Ethernet straight cable, make sure the PBX
is disconnected from the LAN and then connect the PC with an Ethernet straight cable using
192.168.0.101 for the IP address of the IPCEMPR card.
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*3
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*4
Valid IP address range: "1.0.0.0" to "223.255.255.255"
14
Programming Manual for Virtual SIP CO Line Card
Document Version 2008-11
2.1.1 Installing and Starting the Maintenance Console
