Programming
33
Changing the handset name
Each handset can be given a customized
name (“Bob”, “Kitchen”, etc.). This is useful
when you make intercom calls between
handsets. You can also select whether or not
the handset name is displayed in standby
mode. The default setting is
“
No
”
. If you select
“
Yes
”
without entering any handset name,
“
Handset 1
”
to
“
Handset 2
”
is displayed.
1
{
MENU
}
y
1
z
4
2
Enter the desired name (max. 10
characters; see the character table, page
24, 47).
L
If not required, go to step 3.
3
{
OK
}
4
{
r
}
: Select the desired setting.
s
{
OK
}
2
times
5
{
OFF
}
Incoming call barring (Caller ID
subscribers only)
This feature allows the unit to reject calls from
specified phone numbers that you do not want
to answer such as junk calls.
When a call is received, the unit does not ring
while the caller is being identified. If the phone
number matches an entry in the call barred list,
the unit sends out a busy tone to the caller, and
then disconnects the call.
Important:
L
When the unit receives a call from a number
that is stored in the call barred list, the call is
logged in the caller list (page 34) with
$
after the call is disconnected.
Storing unwanted callers
You can store up to 30 phone numbers in the
call barred list.
Important:
L
You must store the phone number with an
area code in the call barred list.
■
From the caller list:
1
{
3
}
CID
2
{
r
}
: Select the entry to be barred.
3
{
SAVE
}
4
{
r
}
:
“
Caller Barred
”
s
{
OK
}
5
{
r
}
:
“
Yes
”
s
{
OK
}
6
{
OFF
}
■
By entering phone numbers:
1
{
MENU
}
y
217
s
{
ADD
}
2
Enter the phone number (24 digits
max.).
L
To erase a digit, press
{
CLEAR
}
.
3
{
OK
}
s
{
OFF
}
Viewing/editing/erasing bar call
numbers
1
{
MENU
}
y
217
2
{
r
}
: Select the desired entry.
L
To exit, press
{
OFF
}
.
3
To edit a number:
{
EDIT
}
s
Edit the phone number.
s
{
OK
}
s
{
OFF
}
To erase a number:
{
ERASE
}
s
{
r
}
:
“
Yes
”
s
{
OK
}
s
{
OFF
}
Note:
L
When editing, press the desired dial key to
add,
{
CLEAR
}
to erase.
TG37xx38xxBX(e).book Page 33 Wednesday, June 8, 2011 2:08 PM
