22
KX-TG6611CXB/KX-TG6611CXS/KX-TG6612CXB/KX-TG6612CXS/KX-TGA661CXB/KX-TGA661CXS
8.3.
How to Clear User Setting
Units are reset to the Factory settings by this operation (Erase stored Phone numbers, Caller list and etc.)
Note:
• Some menus are not reset. Refer to
• The reset menus differ depending on the following operations.
•
This operation should not be performed for a usual repair.
8.3.1.
Resetting both base unit and handset
Both the base unit and the registered handset which you did the following steps
to
are reset. Other registered handsets
will not be reset.
Note:
(*1) Refer to
Registering a Handset to a Base Unit
in the Operating Instructions.
8.3.2.
Resetting only handset
The only handset is reset by doing the following steps
to
.
Note:
(*2)
• The handset registration to the base unit is cancelled.
• If the handset needs to be registered to the base unit, refer to
Registering a Handset to a Base Unit
in the Operating
Instructions.
• If users do not bring the base unit with them, the registration procedure has to be done by users themselves.
1
Connect the AC adaptor to the base unit and install the charged batteries into the handset.
2
Confirm the handset is registered to the base unit ( lights).
If the handset is not registered to the base unit ( lights), register it. (*1)
3
Lift the handset and press
{ih}
to put the handset in standby mode.
4
Press , , and key of the handset simultaneously until a confirmation tone is heard.
5
Disconnect the AC adaptor, then remove the battery.
1
5
9
Handset
Base unit
w
1
Install the charged batteries into the handset.
2
Lift the handset and press
{ih}
to put the handset in standby mode.
4
Remove the battery.
3
Press , , and key of the handset simultaneously until a confirmation tone is heard. (*2)
3
5
7
#
Handset
