Multi-unit Operation
37
Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Operating additional units
Additional handsets
Up to 6 handsets can be registered to a
single base unit. Additional handsets will
give you the freedom to, for example, have
an intercom call with another handset while
a third handset is on an outside call. See
page 4 for information on ordering additional
handsets.
Important:
L
The additional handset model
recommended for use with this unit is
noted on page 4. If other model handset is
used, certain operations (handset
settings, base unit settings, etc.) may not
be available.
Additional base units
Handsets can be registered to up to 4 base
units, allowing you to add additional base
units and extend the area in which your
handset(s) can be used. If a handset moves
out of range of its base unit when
“
Auto
”
is
selected on base unit selection (page 38), it
will look for another base unit to make or
receive calls. A base unit and the handsets it
communicates with is called a “radio cell”.
Note:
L
Calls will be disconnected when the
handset moves from one radio cell to
another.
Registering a handset to a
base unit
The included handset and base unit are
preregistered. If for some reason the
handset is not registered to the base unit (for
example,
w
flashes even when the handset
is near the base unit), register the handset
manually (page 37).
To register an additional handset to a
base unit (easy registration)
After purchasing an additional handset,
register it to the base unit. Ensure that the
additional handset is switched on. If it is not
on, press and hold
{ih}
for few seconds
to turn the handset on.
1
Lift the additional handset and press
{ih}
to put the handset in standby
mode.
2
Press and hold
{x}
on the base unit for
about 3 seconds, until the registration
tone sounds.
3
Place the additional handset on the
base unit. The registration tone
continues to sound. With the handset
still on the base unit, wait until a
confirmation tone sounds and
w
stops
flashing.
Note:
L
If an error tone sounds, or if
w
is still
flashing, register the handset manually
(manual registration; page 37).
L
If all registered handsets start ringing in
step 2, press
{x}
to stop. Start again from
step 1.
L
Charge the batteries of your additional
handset for about 7 hours before initial
use.
L
This registration method cannot be used
for handsets that have already been
registered to a base unit. Register the
handset manually (manual registration;
page 37).
To register a handset to an additional
base unit (manual registration)
You can register a handset to a base unit
manually using the following method.
1
"
(middle soft key)
i
N
i
#
2
“
Registration
”
i
#
TG8100-8120E(e).book Page 37 Friday, March 3, 2006 10:34 AM
