Useful Information
45
The handset display is blank.
L
The handset is in screen saver mode (page 10).
Press
{ih}
to activate the handset display again.
L
The handset is not turned on. Turn the power on
(page 10).
The handset will not turn on.
L
Make sure that the batteries are installed correctly
(page 9).
L
Fully charge the batteries (page 9).
L
Clean the charge contacts and charge again (page
9).
I have changed the display
language to a language I cannot
read.
L
Change the display language (page 11).
I cannot make or receive calls.
L
The AC adaptor or telephone line cord is not
connected. Check the connections.
L
If you are using a splitter to connect the unit,
remove the splitter and connect the unit to the wall
socket directly. If the unit operates properly, check
the splitter.
L
Disconnect the base unit from the telephone line
and connect the line to a known working telephone.
If the working telephone operates properly, contact
our service personnel to have the unit repaired. If
the working telephone does not operate properly,
contact your service provider/telephone company.
L
The dialling mode setting is incorrect. Set to
“
Tone
”
or
“
Pulse
”
as needed (page 11).
L
You dialled a call restricted number (page 24).
L
The key lock feature is turned on. Turn it off (page
14).
The unit does not ring.
L
The ringer volume is turned off. Adjust the ringer
volume (page 19, 23).
L
The night mode feature is turned on. Turn it off
(page 21).
The batteries should be charging
but the battery icon does not
change.
L
Clean the charge contacts and charge again (page
9).
A busy tone is heard when
{C}
is
pressed.
L
The handset is too far from the base unit. Move
closer and try again.
L
Another handset is in use or the answering system
is being used. Wait and try again later.
Problem
Cause & solution
TG8100-8120FX(e).book Page 45 Wednesday, August 9, 2006 3:13 PM