Useful Information
46
Static is heard, sound cuts in and
out. Interference from other
electrical units.
L
Place the handset and the base unit away from
other electrical appliances.
L
Move closer to the base unit.
L
If your unit is connected to a telephone line with
DSL service, the DSL service may be interfering
with your telephone service. We recommend
connecting a filter to the telephone line between the
base unit and the telephone line jack. Contact your
DSL service provider for more information.
Noise is heard during a call.
L
You are using the handset or base unit in an area
with high electrical interference. Place the handset
and base unit away from interference sources, such
as antennas and mobile phones.
The handset/base unit stops
working while being used.
L
Disconnect the AC adaptor and turn off the
handset. Connect the AC adaptor, turn on the
handset and try again.
Pressing
B
does not display/dial
the last number dialled.
L
The redialled number was more than 24 digits long.
Redial the number manually.
Mute does not turn off after the line
is connected.
L
Press
{
C/
T
}
.
The handset beeps intermittently
and/or
3
flashes.
L
Fully charge the batteries (page 9).
I fully charged the batteries, but
3
still flashes.
L
Clean the charge contacts and charge again (page
9).
L
It is time to replace the batteries (page 9).
Caller information is not displayed.
L
You must subscribe to Caller ID service.
L
Consult your service provider/telephone company.
L
If your unit is connected to a telephone line with
DSL service, the DSL service may be interfering
with your telephone service. We recommend
connecting a filter to the telephone line between the
base unit and the telephone line jack. Contact your
DSL service provider for more information.
While viewing caller information,
the display returns to standby
mode.
L
Do not pause for over 1 minute while searching.
Problem
Cause & solution
TG8100-8120FX(e).book Page 46 Wednesday, August 9, 2006 3:13 PM
