X
SMS (Short Message Service)
32
Sending a message
Writing and sending a new
message
1
"
(centre of joystick)
i
X
i
#
2
{^}
/
{V}
:
“
Create
”
i
#
L
If
“
^
Use Last Text?
”
is
displayed, you can use the text
from the last message you
created by pushing the joystick
up.
3
Enter the message (page 44).
i
#
4
Enter the destination phone number
(20 digits max.).
i
#
■
Using the redial list:
Press
j
repeatedly to select
the phone number.
i
#
2
times
■
Using the caller list:
{^}
/
{V}
: Select the party.
i
#
2 times
■
Using the handset phonebook:
n
i
{^}
/
{V}
: Select the
handset phonebook entry.
i
#
2 times
5
To save the message, select
“
Yes
”
.
i
#
6
To send the message, press
#
.
L
To cancel sending, press
{ih}
.
Note:
L
This unit supports SMS messages of
up to 612 characters, however, the
maximum number of characters you
can send or receive may be limited by
your SMS service provider/telephone
company. Consult your SMS service
provider/telephone company for
details.
L
If your message contains over 160
characters, the message is a long
message and
j
is displayed. Your
service provider/telephone company
may treat long messages differently
from other messages. Consult your
service provider/telephone company
for details.
L
If your phone is connected to a PBX,
store the PBX line access number
(page 34).
Sending a saved message
1
"
(centre of joystick)
i
X
i
#
2
{^}
/
{V}
:
“
Send List
”
i
#
3
To read a saved message, push the
joystick up or down to select the
message.
i
#
4
To send the message, press
"
.
i
{^}
/
{V}
:
“
Send
”
i
#
5
Press and hold
{
C/
T
}
to erase all
numbers.
6
Continue from step 4, “Writing and
sending a new message”, page 32.
Editing and sending a saved
message
1
"
(centre of joystick)
i
X
i
#
2
{^}
/
{V}
:
“
Send List
”
i
#
3
{^}
/
{V}
: Select a message.
i
#
4
"
i
{^}
/
{V}
:
“
Edit Message
”
i
#
5
Continue from step 3, “Writing and
sending a new message”, page 32.
Erasing saved messages
1
"
(centre of joystick)
i
X
i
#
2
{^}
/
{V}
:
“
Send List
”
i
#
TG8200_8220FX(e-e).book Page 32 Monday, August 6, 2007 5:25 PM
