Useful Information
48
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect
the base unit AC adaptor and turn off the handset, then reconnect the base unit AC
adaptor and turn on the handset.
Telephone
Problem
Cause & solution
w
is flashing.
L
The handset is not registered to the base unit. Register
it (page 40).
L
The handset is too far from the base unit. Move closer.
L
The base unit AC adaptor is not connected. Check the
connections.
L
You are using the handset or base unit in an area with
high electrical interference. Place the handset and
base unit away from interference sources, such as
antennas and mobile phones.
The handset display is
blank.
L
The handset is in screen saver mode (page 12). Press
{ih}
to activate the handset display again.
L
The handset is not turned on. Turn the power on (page
12).
The handset will not
turn on.
L
Make sure that the batteries are installed correctly
(page 11).
L
Fully charge the batteries (page 11).
L
Clean the charge contacts and charge again (page
12).
I have changed the
display language to a
language I cannot
read.
L
Change the display language (page 13).
TG8200_8220FX(e-e).book Page 48 Monday, August 6, 2007 5:25 PM