Voice mail service for
landline
Voice mail is an automatic answering service
offered by your service provider/telephone
company. After you subscribe to this service, your
service provider/telephone company’s voice mail
system answers calls for you when you are
unavailable to answer the phone or when your line
is busy. Messages are recorded by your service
provider/telephone company, not your telephone.
Please contact your service provider/telephone
company for details of this service.
Important:
R
To use the voice mail service provided by your
service provider/telephone company rather than
the unit’s answering system, turn off the
answering system (page 54). For details, see
page 60.
Voice mail message indication
When you have new voice mail messages,
“
Voice Mail:
”
and/or
“
Voice Mail:
”
is
displayed if message indication service is available.
In order to listen to your voice mail messages, you
must dial the voice mail access number of your
service provider/telephone company.
Note for handset and base unit:
R
If the handset and base unit still indicate there
are new messages even after you have listened
to all new messages, turn it off by pressing and
holding
#
until the handset or base unit beeps.
Voice mail (VM) tone detection
Handset / Base unit
Your service provider/telephone company sends
special signals (sometimes called “voice mail
tones” or “stutter tones”) to the unit to let you know
you have new voice mail messages. If you hear a
series of dial tones followed by a continuous dial
tone after you press
M
N
on the handset or press
MZN
on the base unit, you have new voice mail
messages. Soon after you hang up a call or after
the phone stops ringing, your unit checks the
phone line to see if new voice mail messages
have been recorded.
Turn this feature off when:
– You do not subscribe to voice mail service.
– Your service provider/telephone company does
not send voice mail tones.
– Your phone is connected to a PBX.
If you are not sure which setting is required,
contact your service provider/telephone company.
Turning VM tone detection on/off
The default setting is
“
On
”
.
Program this setting using either the base unit or
one of the handsets.
Handset / Base unit
1
M
MENU
N#332
2
MbN
: Select the desired setting.
a
M
SAVE
N
3
Proceed with the operation for your unit.
Handset:
M
OFF
N
Base unit:
M
EXIT
N
Wall mounting
The base unit can be mounted on a wall by
changing the wall mounting adaptor’s position.
Note:
R
Make sure that the wall and the fixing method
are strong enough to support the weight of the
unit.
Base unit
1
To remove the wall mounting adaptor, push
down the release levers (
A
). Remove the
adaptor (
B
).
A
A
B
B
B
B
2
A
Turn the adaptor so that the words “UP
WALL” are facing up.
B
Tuck the telephone line cord inside the wall
mounting adaptor.
62
For assistance, please visit http://www.panasonic.com/help
Useful Information
TG954x(en)_0528_ver011.pdf 62
2013/05/28 11:09:55
